Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Have you followed through on your New Years resolution?
02-26-2015, 05:21 PM
Post: #1
Have you followed through on your New Years resolution?
For those who made one it's been almost 2 months...have you stuck to it?

http://fredfred5150.deviantart.com/ Commission status: Closed
Find all posts by this user
02-26-2015, 07:30 PM
Post: #2
RE: Have you followed through on your New Years resolution?
I never really make specific resolutions, I just tell myself I wanna do what I did last year only better/more. So far it seems to be working out.
Find all posts by this user
02-26-2015, 09:29 PM
Post: #3
RE: Have you followed through on your New Years resolution?
I don't even remember what mine was... usually my resolution is no resolution because no matter how good intentioned it is everyone always fails miserably and at least that way I could watch everyone else fail and not have to fail myself.

tumblrs: innie pussies | round asses
Find all posts by this user
03-03-2015, 12:10 AM
Post: #4
RE: Have you followed through on your New Years resolution?
This year, I decided to make resolutions that would be easy to keep - and ones I was going to do anyway.

1. Get new glasses, specifically bifocals. Done. Progressive lenses are weird. Still not used to not seeing my feet in focus when I walk down stairs.
2. Upgrade my wardrobe. In Progress. Got some new pants, and will be getting some shirts later this month.
3. Get a new chair for my bedroom desk. Incomplete. I have a small bedroom; the chairs I'm interested in would take up too much volume in an already cramped room.
Find all posts by this user
03-03-2015, 02:43 PM
Post: #5
RE: Have you followed through on your New Years resolution?
I'm doing ok-ish on my weight loss resolution. I'm generally eating less, but had a few moments where I found myself stress-eating.

I'm also trying to exercise more, but its difficult at times, especially as I'm stuck behind a desk at work, not much opportunity to get up and walk around for a while.
Find all posts by this user


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Affect3D.com - the 3DX magazine | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication